MS5168-M05

Introduction

The MS5168-Myy family is a range of ultra-low power, high performance surface mount modules targeted at IEEE 802.15.4, JenNet-IP, ZigBee Light Link, ZigBee Smart Energy and RF4CE networking applications, enabling users to realize products with minimum time to market and at the lowest cost. They remove the need for expensive and lengthy development of custom RF board designs and test suites. The modules use NXP’s MS5168 wireless microcontroller to provide a comprehensive solution with large memory, high CPU and radio performance and all RF components included. All that is required to develop and manufacture wireless control or sensing products is to connect a power supply and peripherals such as switches, actuators and sensors, considerably simplifying product development.

Click here to buy MS5168-M05 form taiwantrade.com

Variants

Module	Chip	Power	Antenna	Dimension(mm)	Certification
MS5168-M00	JN5168-001	Standard	PCB Antenna	30x16x2.8	FCC
MS5168-M03	JN5168-001	Standard	u-FL connector	21x16x2.8	FCC
MS5168-M04	JN5168-001	High	u-FL connector	30x16x2.8	FCC *1
MS5168-M05	JN5168-001	High	PCB Antenna	30x16x2.8	FCC/CE 12
MS5168-M14	JN5168-001	High	u-FL connector	30x16x2.8	FCC/CE 12
MS5169-M03	JN5169-001	Middle	u-FL Connector	21x16x2.8	FCC

Table 1 Meshreen module variants

*1 FCC Certification Limitation:The high power module variants are classified as ‘mobile’ devices pursuant
with FCC § 2.1091 and must not be used at a distance of < 20 cm (8”) from any people. This applies to the
MS5168-M04 and MS5168-M05 module type (2AC2E-68M04).

*2 CE Certification Limitation: MS5168-M14 and MS5168-M05 CE tested under condition Power Level 2.

Specification

There are differences between modules, the parameters are defined here.

VDD=3.3V @ +25°C

Typical DC Characteristics					Notes
	M00/03	M04/05	M14	MS5169-M03
Deep sleep current	100nA	100nA	100nA	100nA
Sleep Current	0.70uA	0.70uA	0.70uA	0.73µA	With active sleep timer
Radio Transmit current	15.3mA	150mA	150mA	23.3mA	CPU + Protocol + radio transmitting
Radio receive current	17mA	22mA	22mA	15mA	CPU in doze + radio receiving
Centre frequency accuracy	+/-10ppm	+/-10ppm	+/-10ppm	+/-10ppm	Additional +/-15ppm allowance for temperature and ageing

Typical RF Characteristics					Notes
	M00/03	M04/05	M14	MS5169-M03
Receive sensitivity	-95dBm	-100dBm	-98dBm	-95dBm	Nominal for 1% PER, as per 802.15.4 section 6.5.3.3 (Note 1)
Maximum Transmit power	+0dBm	+18dBm	+6dBm(Power Level=2)	+9dBm
Maximum input signal	10dBm	+5dBm	+5dBm	+10dBm	For 1% PER, measured as sensitivity
RSSI range (dBm)	-95 ~ -10dBm	-105 ~ -20	-105 ~ -20	-95~-10dBm
RF Port impedance – SMA/uFl connector	50 ohm	50 ohm	50 ohm	50 ohm	2.4 - 2.5GHz
Rx Spurious Emissions	-61dBm	-69dBm	-69dBm	-70dBm	Measured conducted into 50 ohms
Tx Spurious Emissions	-40dBm	-49dBm	-49dBm	-65dBm	Measured conducted into 50 ohms
VSWR (max)	2:1	2:1	2:1	2:1	2.4 - 2.5GHz

Peripherals					Notes
	M00/03	M04/05	M14	MS5169-M03
Master SPI port	3 selects	3 selects	3 selects	3 selects	250kHz - 16MHz
Slave SPI port	√	√	√	√	16550 compatible
Two-wire serial I/F (compatible with SMbus & I2C)	√	√	√	√	Up to 400kHz
5 x PWM (4 x timer, 1x timer/counter)	√	√	√	√	16MHz clock
Two programmable Sleep Timers	√	√	√	√	32kHz clock
Digital IO lines (multiplexed with UARTs, timers and SPI selects)	20	20	18	18	10-bit, up to 100ks/s
Four channel Analogue-to-Digital converter	√	√	√	√	Ultra low power mode for sleep
Programmable analogue comparators	√	√	√	√